Cisco Asr 9000 Series Aggregation Services Router Interface And Hardware Component Command Reference - Cisco ASR 9000 Series Command Reference Manual

profile (SLA)
You can configure the Ethernet SLA profile to use Y.1731 DMM frames. The restriction of 150 configured
Note
Ethernet SLA operations for each CFM MEP is removed not only for profiles using DMM frames, but
also for profiles using the other supported Y.1731 frame types, such as loopback measurement and synthetic
loss measurement. For interoperability purposes, it is still possible to configure profiles to use DMM v0
frames. This is done by specifying a type of cfm-delay-measurement-v0 on the profile(SLA) command.
The limit of 150 configured operations for each CFM MEP still applies in this case.
Task ID
Task ID
ethernet-services
Examples This example shows how to configure an SLA operation profile and enter the SLA profile configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# ethernet sla
RP/0/RSP0/CPU0:router(config-sla)# profile
RP/0/RSP0/CPU0:router(config-sla-prof)#

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Release 5.3.x
302
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
Operations
read, write
Prof1 type cfm-loopback