Cisco ASR 9000 Series Command Reference Manual page 983

T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
• If specifying a virtual interface, the number range varies, depending on interface type.
• When specifying a virtual tributary group, the naming notation is rack/slot/module/port/vtg/vt. The slash
Task ID
Task ID
dwdm
interface
sonet-sdh
Examples The following example shows how to clear controller data for the channelized T1 controller 1 that is located
in chassis 0, for a SIP installed in slot 1 with a SPA in subslot 0, and port 0 with T3 controller 1, and channelized
T1 controller 1:
RP/0/RSP0/CPU0:router# clear controller t1 0/1/0/0/1/1
Related Commands
Command
controller t1, on page 974
show controllers t1, on page 1046
between values is required as part of the notation. An explanation of each component of the naming
notation is as follows:
◦rack—Chassis number of the rack.
◦slot—Physical slot number of the line card.
◦module—Module number or subslot (for a SPA). A physical layer interface module (PLIM) is
always 0.
◦port—Physical port number of the interface.
◦vtg—Virtual tributary group.
◦vt—Virtual tributary instance.
To view the status of the controllers, use the show controllers t1 command.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Operations
read, write
read, write
read, write
Description
Displays information about the T1 links and hardware and
software drivers for the T1 controller.
clear controller t1
Release 5.3.x
963