Ppp Ipcp Neighbor-Route Disable - Cisco ASR 9000 Series Command Reference Manual

ppp ipcp neighbor-route disable

ppp ipcp neighbor-route disable
To disable installation of a route to the peer address negotiated by Internet Protocol Control Protocol (IPCP),
use the ppp ipcp neighbor-route disable command in interface configuration mode. To re-enable installation
of a route to the peer address negotiated by IPCP, use the no form of this command.
ppp ipcp neighbor-route disable
no ppp ipcp neighbor-route disable
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
Release
Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
ppp
Examples
The following example shows how to disable installation of a route to the peer address negotiated by IPCP:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ppp ipcp neighbor-route disable
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
728
PPP Commands onthe Cisco ASR 9000 Series Router
Modification
This command was introduced.
Operations
read, write