Cisco Asr 9000 Series Aggregation Services Router Interface And Hardware Component Command Reference - Cisco ASR 9000 Series Command Reference Manual

Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
admin-state
This is a required configuration. The DWDM cards will not operate without this configuration.
Note
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# controller dwdm 0/1/0/1
RP/0/RSP0/CPU0:router(config-dwdm)# admin-state in-service
RP/0/RSP0/CPU0:router(config-dwdm)# commit
The following example shows how to stop all operation on a DWDM port:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# controller dwdm 0/1/0/1
RP/0/RSP0/CPU0:router(config-dwdm)# admin-state out-of-service

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,

Release 5.3.x
4