Lldp Timer - Cisco ASR 9000 Series Command Reference Manual

lldp timer

lldp timer

To specify the Link Layer Discovery Protocol (LLDP) packet rate, use the lldp timer command in global
configuration mode. To return to the default, use the no form of this command.
lldp timer seconds
no lldp timer seconds
Syntax Description
seconds
Command Default
LLDP packets are sent every 30 seconds.
Command Modes
Global configuration (config)
Command History
Release
Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
ethernet-services
Examples The following example shows how to change the default LLDP packet rate from 30 seconds to 1 minute:
RP/0/RSP0/CPU0:router(config)# lldp timer 60
Related Commands
Command
lldp, on page 87
show lldp, on page 110
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
94
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
Number from 5 to 65534 that specifies the rate (in seconds) at which to send LLDP
packets. The default is 30.
Modification
This command was introduced.
Description
Enables LLDP globally for both transmit and receive operation on
the system.
Displays the global LLDP operational characteristics on the system.
Operation
read, write