Servo Amplifier Connectors (Cnp1, Cnp2) Wiring Method (When Mr-Ecpn1-B And Mr-Ecpn2-B Of An Option Are Used.) - Mitsubishi Electric EZMOTION MR-E Super MR-E-10A-QW003 Instruction Manual

3. SIGNALS AND WIRING
3.11 Servo amplifier connectors (CNP1, CNP2) wiring method (When MR-ECPN1-B and MR-ECPN2-B of an
option are used.)
(1) Termination of the cables
Solid wire: After the sheath has been stripped, the cable can be used as it is.
www.DataSheet4U.com
Twisted wire: Use the cable after stripping the sheath and twisting the core. At this time, take care to avoid
POINT
For the wire sizes used for wiring, refer to Table 13.1 1), 2) and 3) of section
13.2.1.
a short caused by the loose wires of the core and the adjacent pole. Do not solder the core
as it may cause a contact fault.
8 to 9 mm
3 - 45