Configuring An Extended Ip Acl; Figure 3-42 Configuring Standard Ip Acls - Edge-Core ES4524M-PoE Management Manual

indicate "ignore." The mask is bitwise ANDed with the specified source IP address,
and compared with the address for each IP packet entering the port(s) to which this
ACL has been assigned.
Web – Specify the action (i.e., Permit or Deny). Select the address type (Any, Host,
or IP). If you select "Host," enter a specific address. If you select "IP," enter a subnet
address and the mask for an address range. Then click Add.
CLI – This example configures one permit rule for the specific address 10.1.1.21
and another rule for the address range 168.92.16.x – 168.92.31.x using a bitmask.
Console(config-std-acl)#permit host 10.1.1.21
Console(config-std-acl)#permit 168.92.16.0 255.255.240.0
Console(config-std-acl)#

Configuring an Extended IP ACL

Command Attributes
• Action – An ACL can contain either all permit rules or all deny rules.
(Default: Permit rules)
• Source/Destination Address Type – Specifies the source or destination IP
address. Use "Any" to include all possible addresses, "Host" to specify a specific
host address in the Address field, or "IP" to specify a range of addresses with the
Address and SubMask fields. (Options: Any, Host, IP; Default: Any)
• Source/Destination IP Address – Source or destination IP address.
• Source/Destination Subnet Mask – Subnet mask for source or destination
address. (See the description for SubMask on page 3-82.)

Figure 3-42 Configuring Standard IP ACLs

Client Security
4-124
3-83