Adding An Interface To A Qinq Tunnel - Edge-Core ECS3510-10PD Management Manual

A I
DDING AN NTERFACE
Q Q T
TO A IN UNNEL
To show the mapping table:
Click VLAN, Tunnel.
1.
Select Configure Service from the Step list.
2.
Select Show from the Action list.
3.
Select an interface from the Port list.
4.
Figure 82: Showing CVLAN to SPVLAN Mapping Entries
The preceding example sets the SVID to 99 in the outer tag for egress
packets exiting port 1 when the packet's CVID is 2. For a more detailed
example, see the switchport dot1q-tunnel service match cvid
Follow the guidelines in the preceding section to set up a QinQ tunnel on
the switch. Then use the VLAN > Tunnel (Configure Interface) page to set
the tunnel mode for any participating interface.
CLI R
EFERENCES
"Configuring IEEE 802.1Q Tunneling" on page 1146
◆
C U
OMMAND SAGE
Use the Configure Global page to set the switch to QinQ mode before
◆
configuring a tunnel access port or tunnel uplink port (see
QinQ Tunneling on the Switch" on page
Identifier (TPID) value of the tunnel access port if the attached client is
using a nonstandard 2-byte ethertype to identify 802.1Q tagged
frames.
Then use the Configure Interface page to set the access interface on
◆
the edge switch to Access mode, and set the uplink interface on the
switch attached to the service provider network to Uplink mode.
P
ARAMETERS
These parameters are displayed:
Interface – Displays a list of ports or trunks.
◆
Port – Port Identifier. (Range: 1-10)
◆
– 217 –
| VLAN Configuration
C 6
HAPTER
IEEE 802.1Q Tunneling
command.
"Enabling
214). Also set the Tag Protocol