Configuring A Dynamic Trunk - Edge-Core ES3510MA Management Manual

To display trunk connection parameters:
Click Interface, Trunk, Static.
1.
Select Configure General from the Step list.
2.
Select Show Information from the Action list.
3.
Figure 41: Showing Information for Static Trunks
Use the Interface > Trunk > Dynamic (Configure Aggregator) page to set
C
ONFIGURING A
the administrative key for an aggregation group, enable LACP on a port,
D T
YNAMIC RUNK
and configure protocol parameters for local and partner ports.
Figure 42: Configuring Dynamic Trunks
CLI R
"Link Aggregation Commands" on page 717
◆
C
OMMAND
To avoid creating a loop in the network, be sure you enable LACP before
◆
connecting the ports, and also disconnect the ports before disabling
LACP.
If the target switch has also enabled LACP on the connected ports, the
◆
trunk will be activated automatically.
◆ A trunk formed with another switch using LACP will automatically be
assigned the next available trunk ID.
If more than eight ports attached to the same target switch have LACP
◆
enabled, the additional ports will be placed in standby mode, and will
only be enabled if one of the active links fails.
active
links
EFERENCES
U
SAGE
– 137 –
| Interface Configuration
C 5
HAPTER
dynamically
enabled
backup
link
configured
members
Trunk Configuration