Averaging Times - Thermo Scientific 49i Instruction Manual

Thermo Fisher Scientific
set avg time selection
set high avg time selection
set low avg time selection
These commands set the averaging time, high and low averaging times,
according to Table B-2. The example that follows sets the low range
averaging time to 120 seconds.
Send: set low avg time 5
Receive: set low avg time 5 ok
Table B-2. Averaging Times
Selection Averaging Time (seconds)
0 10
1 20
2 30
3 60
4 90
5 120
6 180
7 240
8 300
bench temp
This reports the current bench temperature. The first temperature reading is
the temperature being used in instrument calculations. The second
temperature is the actual temperature being measured. If temperature
compensation is ON, then both temperature readings are the same. If
temperature compensation is OFF, a temperature of 0
default temperature even though the actual bench temperature is 32.3
The example that follows shows that temperature compensation is on and
that the bench temperature is 32.3
Send: bench temp
Receive: bench temp 032.3 deg C, actual 032.3
o3
high o3
low o3
These commands report the measured O
in single range, or high and low O
mode. The example that follows shows that the O
ppb.
C-Link Protocol Commands
C is used as the
°
C.
°
concentrations when operating
3
when operating in dual or auto range
3
concentration is 67.2
3
Model 49i Instruction Manual
Measurements
C.
°
B-9