Thermo Scientific 49i Instruction Manual page 87

Instrument State
Thermo Fisher Scientific
OUTPUT RELAY SETUP:
>LOGIC STATE
INSTRUMENT STATE
RANGE
The Instrument State submenu allows the user to select the instrument state
that is tied to the selected relay output. A submenu lists signal types of
either alarm and non-alarm to choose from.
• In the Main Menu, choose Instrument Controls > I/O Configuration >
Output Relay Settings > Select Relay > Instrument State.
CHOOSE SIGNAL TYPE:
>ALARMS
NON-ALARM
RANGE
Alarms The Alarms status screen allows the user to select the alarm status for the
selected relay output. The selected item is shown by "<--" after it. The I/O
board status alarm is present only if the I/O expansion board is installed.
The zero and span check/calibration alarms are present only if the zero/span
valve option is installed and the instrument is operating in manual mode.
• In the Main Menu, choose Instrument Controls > I/O Configuration >
Output Relay Settings > Select Relay > Instrument State > Alarms.
• Use
• Press
OPEN
AVG DIAGS ALARM
AVG DIAGS ALARM
and to scroll through a list of choices.
to save the new selection for the relay.
Operation
Instrument Controls Menu
Model 49i Instruction Manual 3-51