Appendix B C-Link Protocol Commands - Thermo Scientific 49i Instruction Manual

Thermo Fisher Scientific
C-Link Protocol Commands
Appendix B
This appendix provides a description of the C-Link protocol commands
that can be used to remotely control a Model 49i analyzer using a host
device such as a PC or a datalogger. C-Link protocol may be used over
RS-232, RS-485, or Ethernet. C-Link functions can be accessed over
Ethernet using TCP/IP port 9880.
• "Instrument Identification Number"
command format.
• "Commands" on page B-2
Table B-1.
• "Measurements" on
measurement commands.
• "Alarms" on page B-11
commands.
• "Diagnostics" on page B-16
diagnostic commands.
• "Datalogging" on page B-17
datalogging commands.
• "Calibration" on page B-24
calibration commands.
• "Keys/Display" on
and display commands.
• "Measurement Configuration"
examples of the measurement configuration commands.
• "Hardware Configuration"
of the hardware commands.
• "Communications Configuration"
examples of the communication commands.
on page B-2
lists all the 49i C-Link commands in
page B-8 describes and gives examples of the
describes and gives examples of the alarm
describes and gives examples of the
describes and gives examples of the
describes and gives examples of the
page B-26 describes and gives examples of the keys
on page B-29
on page B-33 describes and gives examples
on page B-35
describes the C-Link
describes and gives
describes and gives
Model 49i Instruction Manual B-1