Measurements - Thermo Scientific 49i Instruction Manual

C-Link Protocol Commands

Measurements

Measurements
B-8 Model 49i Instruction Manual
Table B-1. C-Link Protocol Commands, continued
Command Description
resp coef Reports/sets instrument response
ri (right) Simulates pressing right pushbutton
ru (run) Simulates pressing run pushbutton
sample Sets zero/span valves to sample mode
save Stores parameters in FLASH
save params Stores parameters in FLASH
sc (screen) C-series legacy command that reports a generic response (Use
iscreen instead)
sp conc Reports/sets the span concentration for autocalibration
sp field Reports/sets item number and name in scratch pad list
span Sets zero/span valves to span mode
sr Reports last short record stored
srec Reports maximum number of short records
srec format Reports/sets output format for short records (ASCII or binary)
srec layout Reports current layout of short record data
srec mem size Reports maximum number of short records
srec per Reports/sets short record logging period
stream per Reports/sets current set time interval for streaming data
stream time Reports/sets a time stamp to streaming data or not
temp comp Reports/sets temperature compensation on or off
time Reports/sets current time (24-hour time)
up Simulates pressing up pushbutton
zero Sets zero/span valves to zero mode
avg time
high avg time
low avg time
These commands report the averaging time in seconds when operating in
single range, or averaging time used with the high and low ranges when
operating in dual or auto range mode. The example that follows shows that
the averaging time is 300 seconds, according to
Send: avg time
Receive: avg time 11: 300 sec
Table B-2.
Thermo Fisher Scientific
Page
B-26
B-26
B-26
B-31
B-35
B-35
B-28
B-26
B-22
B-31
B-18
B-18
B-20
B-20
B-21
B-21
B-23
B-23
B-32
B-35
B-27
B-31