The Dashboard
The Dashboard is comprised of all control and information GUI elements seen when you first start the
application. You can perform many powerful operations and quickly access most of the functions from the
Dashboard.
Device Connections
Two Device Connection buttons are shown on the upper‐left corner of the screen, just below the menu bars.
These buttons handle digital pod and oscilloscope device connections, respectively. Clicking either button
attempts to connect to the device or disconnect from the device (depending on the current state). These
buttons have a blue glow when the status is connected.
A red X over the button indicates the device is not currently present or has been explicitly disconnected by the
user.
You cannot make new acquisitions without a connection to a digital pod. However, you do not need to have an
oscilloscope connected to create acquisitions.
PLEASE NOTE THE FOLLOWING:
•
Manually disabling or disconnecting the oscilloscope can speed up the rate of acquisitions if you
temporarily don't need the analog data.
•
LeCroy's WaveJet series oscilloscope is the instrument used with LogicStudio.
Pin Activity
The Pin Activity display is located at the top of the dashboard. It shows the activity status of all digital device
channels in real‐time (regardless of application or device state).
Setup
Three Setup buttons are directly to the right of the device connection buttons. The Setup buttons allow for
configuring the application and digital device.
918291 RevA
Getting Started Manual
22