Table of Contents
Advertisement
INSTALLATION
Software
Checking the Scope Status
To find out the scope's software and hardware configuration, including software version and
installed options, proceed as follows:
•
In the menu bar, touch
•
Touch the
You can find information related to hard drive memory, etc. as follows:
Minimize the instrument application by touching
1.
down menu.
Touch the Start taskbar button and, per usual Windows® operation, open Windows Explorer.
2.
Default Settings
DDA, SDA, and WaveRunner DSOs
On your front panel, the D
therefore, to recall a default setup
1. Press the S
/R
AVE
Note: You can also touch File in the menu bar, then Recall Setup... in the drop-down menu.
2. Touch the "Recall Setup" tab in the dialog.
3. Then touch the on-screen Recall Default button:
Adding a New Option
To add a software option you need a key code to enable the option. Call LeCroy Customer
Support to place an order and receive the code.
To add the software option do the following:
1. In the menu bar, touch
SDA-OM-E Rev H
.
tab.
S
push button does not exist. For these instruments,
EFAULT
ETUP
push button to the left of the D
ECALL
.
SDA Operator's Manual
, then selecting Minimize in the drop-
A
push button.
RIVE
NALYSIS
53
Advertisement
Table of Contents
