Adjusting The Throttle Cable; Adjusting The Carburetor - Baja DX70 Owner's Manual

ADJUSTING THE THROTTLE CABLE

Make sure the throttle works normally.
Check if the throttle twist grip has the required
free operating movement.
The required free operating movement:
2-4mm (1/16-3/16 in) If the grip cannot be moved
freely, turn adjusting nut located on top of the throttle
twist grip to ensure proper operating movement.
After adjustment, start the engine and check for the operating movement
again. Repeat the adjustment if necessary until the desired operating
movement is obtained.

ADJUSTING THE CARBURETOR

Adjusting procedures of idling speed:
1. Support the vehicle by a stand.
2. Adjust the idling speed by the throttle stop screw to 1500 rpm ± 100 rpm.
CAUTION
Do not try to correct a malfunctioning carburetor by adjusting the idling
speed. If the carburetor is not functioning properly, it should be repaired
by a service center.
Adjust idling speed only when the engine is warmed up or 10 minutes after
operation.
MAINTENANCE
Idling speed adjusting screw
21
2-4mm
1/16 - 3/16 in
Adjust nut