Installation - prime mover smx45 Master Service Manual

© BT Prime-Mover, Inc.
Return
7. Disconnect hydraulic motor power cables and mark
8. Remove screws securing hydraulic pump and
9. Rebuild pump/motor as necessary.

4.2.2. Installation

WARNING
1. Thoroughly clean all parts with non-corrosive
2. Install pump/motor assembly in truck and secure
3. Properly connect electrical power cables and
Power
Cables
4. Uncap and connect hydraulic hose to hydraulic
5. Fill hydraulic reservoir with new clean oil (see
6. Remove blocks.
7. Install battery on truck. If applicable, secure battery
8. Connect the battery connector to the truck.
9. Turn the main ON/OFF switch to the ON position.
10. Check the reservoir fluid level. Operate the truck's
11. Install truck cover(s) [see
Master Service Manual
F-code
PT
Version no
001
their positions. Disconnect contactor wiring, noting
their position.
motor assembly to frame. Remove pump/motor
assembly from truck.
When using compressed air, wear effective
chip-guarding
equipment. Compressed
cleaning MUST be reduced to less than 30
psi (207 kPa).
cleaning fluid and air dry all parts.
with screws to truck frame. (For torque values see
page 47.)
contactor wiring, noting their positions recorded
earlier.
pump assembly.
page 72.)
bolts to the truck.
Enter key code and press the green ON button "I"
on the keypad.
hydraulic system and check operation of system as
a whole. Look for leaks and tight places on the
lifting linkage.
2006-08-04
Section
S1.0
Electric Motors
T-code
SMX
and personal protective
air used for
page 84.]
C-code
1700
93