Maintenance; Mechanical Brake Release; Brake Adjustment - prime mover smx45 Master Service Manual

Mounting Bolts
© BT Prime-Mover, Inc.
Return

2. Maintenance

See "Planned Maintenance Schedule" on page 61.

2.1. Mechanical Brake Release

If the brake can not be mechanically released, perform the
following procedures:
1. Park truck on a level surface and load wheels are
blocked to prevent accidental movement.
2. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
3. Remove truck cover(s) [see
4. Loosen the mounting bolts four turns each to allow
the truck to roll.
5. Move truck to desired location.
Before truck is put back into service, the
WARNING
mounting bolts will need to be tighten. DO
NOT OPERATE TRUCK WITHOUT THE
BRAKE.
6. Reinstall truck cover(s).

2.2. Brake Adjustment

Before adjustments are made, disconnect
WARNING
the battery from the truck to prevent
accidental operation.
1. Park truck on a level surface and make sure
parking brake is applied and load wheels are
blocked to prevent accidental movement.
2. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
3. Disconnect the battery connector from the truck.
4. Jack the truck and block the frame (see
5. Remove truck cover(s) [see
Master Service Manual 2006-08-04
F-code Section
PT S3.0
Parking Brake System
Version no T-code
001 SMX
page 84.]
page 84.]
C-code
3300
page 58.)
111