prime mover smx45 Master Service Manual page 167

© BT Prime-Mover, Inc.
Return
6. Remove the stem mount (see
handle as an assembly from the transmission (see
Figure 5-3.) Remove the old harness from the
truck (see page
Stem
Mount
Transmission
Assembly
Figure 5-3: Stem Handle Mounting
7. Lay the new harness into the truck.
8. Connect the truck end of the harness. For the
proper harness connections, see
schematics see
9. Install the harness down through the transmission
opening and connect cables and wires to the drive
motor terminal block
164.)
10. Check to make sure the power wires are vertically
stacked one on top of the other on the LEFT side of
the transmission opening above the power
terminals and the wire guard with ring terminals
match on see
Master Service Manual
2006-12-12
F-code Section
PT S5.0
Electrical Functions
Version no T-code
002 SMX
page
192.)
Upstop
Stem Handle
Figure
page 194.
(see Figure 5-2 on page
Figure 5-3.
C-code
5000
103) and stem
5-3. For
165