Reservoir - prime mover smx45 Master Service Manual

Electric walkie low-lift pallet truck
Hide thumbs Also See for smx45:
Table of Contents

Advertisement

F-code
Section
PT
S6.0
Hydraulic System
Version no
T-code
001
SMX
268
Return
C-code
6000
Inspection
1. Inspect seat where hydraulic lowering valve stem
seals against the adapter body. The sealing
surface must be completely clean and free from
any nicks or damage.
Installation
1. Thread adapter body into the adapter (32) and
torque to 204 - 240 in-lbs (23 - 27 N•m).
2. Install solenoid coil (13) and torque nut to 48 to 60
in-lbs (5 to 7 N•m).
3. Connect the wires to the terminals.
4. Install truck cover(s).
5. Connect the battery connector to the truck.
6. Turn the main ON/OFF switch to the ON position.
Enter key code and press the green ON button "I"
on the keypad.

4.3. Reservoir

Removal
1. Remove hydraulic unit from truck (see
2. Remove hose clamp securing hydraulic reservoir to
the adapter (32) housing.
3. Tap reservoir (26) lightly to loosen. Wiggle reservoir
sideways while pulling up on the pump and motor at
the same time to remove.
4. Remove reservoir (26) and properly dispose of old
hydraulic fluid.
5. After fluid has drained, flush the inside of the
reservoir with a suitable cleaning solution.
6. Dry the inside of the reservoir with clean, dry
compressed air.
Inspection
1. Inspect the reservoir O ring and inside leading
edge for defects. Replace if necessary.
Master Service Manual
page
266.)
2006-08-08

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents