Parameter Description - prime mover smx45 Master Service Manual

F-code Section
PT S5.0
Electrical Functions
Version no T-code
002 SMX
176
Return
C-code
5000

3.5.1. Parameter Description

Parameter 1
Maximum speed value sent to transistor controller while in
Slow mode except during turtle torque (gives torque boost if
high load is encountered.)
Parameter 2
Reduces speed value sent from the Electronic Tiller Arm
Card (ETAC) to the transistor controller while in Fast mode
(all throttle positions.)
Parameter 3
Defines truck's acceleration characteristic when truck starts
from a stop. A high number gives maximum acceleration, a
lower number gives less aggressive acceleration.
Parameter 4
Defines truck's automatic plug-braking characteristic when
throttle is reduced (including to neutral.) A lower number
gives less aggressive acceleration.
Parameter 5
Time until the truck is switched OFF (energy saving feature)
when truck is idle and the brake is applied. Time is counted
from the latest power output is requested. If truck has the
key switch option, the truck never powers OFF.
Parameter 10
Defines the PIN code for the driver shown. The default
operator PIN-key code is "1". Programming new key codes
must be done using a service key (see
the 10 key codes may be programed individually for operating
parameters.
If two drivers have the same PIN, the higher number driver's
parameters will be used. (EXAMPLE: If both the first and
second driver's PIN codes are 1111 and the first driver's
maximum speed is 80 percent and the second driver's
maximum speed is 90 percent, when someone logs in with
1111 the maximum speed will be 90 percent.) Setting a
driver's PIN code to 0 will disable that driver. By default, the
first driver's PIN code is 1 and all other driver's PIN codes are
0. To enable additional drivers, change these PIN codes to
numbers other than 0. To program operating parameters
proceed as follows:
Master Service Manual
page 174.) Each of
2006-12-12