prime mover smx45 Master Service Manual page 135

© BT Prime-Mover, Inc.
Return
10. Inspect stem harness and washer (10), bushing
(11), spring (12), sleeve (13), and washer (14) for
excessive wear. Replace if necessary.
Installation
NOTE! Make sure brake release cam assembly is
in the correct position before proceeding
with installation procedures.
1. Position steering control handle stem (7) on the
pivot assembly. Secure with screw (5).
2. Thread wiring harness through handle base.
3. If removed, reattach steering control handle head.
4. Connect handle harness connector and arm angle
switch connections. Install cable ties in their
original locations on the handle harness.
5. Install lower steering control handle cover (4).
Secure with screws (1).
Plastic Washer
6. Remove blocks.
7. Connect the battery connector to the truck.
Master Service Manual 2006-08-07
F-code Section
PT S4.0
Steering Control Handle
Version no T-code
001 SMX
Harness Sleeve
Figure 4-3: Control Handle
C-code
4100
Spring
133