Hydraulic Solenoid - prime mover smx45 Master Service Manual

© BT Prime-Mover, Inc.
Return
Installation
1. Install hydraulic unit on the truck and bolt bracket.
2. Install hydraulic line on hydraulic unit.
3. Fill reservoir with specified fluid (see
a funnel with a flexible neck. Fill reservoir to within
1 inch (25.4 mm) below filler plug elbow. Use up to
0.8 quart (0.75 liter).
4. Install vent plug.
5. Connect the wires and cables to the pump motor.
6. Connect the battery connector to the truck. Turn the
main ON/OFF switch to the ON position. Enter key
code and press the green ON button "I" on the
keypad.
7. Raise and lower forks. Check hoses and fittings for
leaks.
8. Check hydraulic fluid level in the reservoir (see
page 257.)
9. Install truck cover(s).

4.2. Hydraulic Solenoid

Removal
1. Lower forks to the floor.
2. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
3. Disconnect the battery connector from the truck.
4. Remove truck cover(s) [see
5. Remove wires from terminals on the solenoid (3).
6. Remove nut holding solenoid coil (13) to the
hydraulic lowering valve (11).
7. Lift solenoid coil (13) off the relief valve (12) stem.
8. Remove relief valve (12) from the adapter (32)
body.
Master Service Manual 2006-08-08
F-code Section
PT S6.0
Hydraulic System
Version no T-code
001 SMX
page
page 84.]
C-code
6000
72.) Use
267