prime mover smx45 Master Service Manual page 276

F-code Section
PT S6.1
Lift Cylinder
Version no T-code
000 SMX
Seal Tool
274
Return
C-code
6420
Assembly
1. Using seal tool, install new seal (5) on the inside
diameter of cylinder tube (6). Install new wiper (4)
with lips facing inward to bottom on cylinder tube
(6).
NOTE!
2. Install new retaining ring (3) in deep groove of
cylinder rod end.
3. Oil outside of cylinder rod (2) and carefully insert in
tube assembly (6).
4. Push cylinder rod (2) in cylinder tube (6) until
retaining ring (3) areas of cylinder rod can be seen
through port.
5. Using a screwdriver through port, move retaining
ring (3) to lock position.
6. Extend cylinder rod (2) to the fully out position to
make sure retaining ring (3) is locked in place.
Installation
1. In order to prevent air from filling the cylinder
assembly, it is recommended that the cylinder rod
(2) is fully retracted.
2. Install upper mount first and hold in place with
shoulder bolt.
3. Connect the hydraulic hose and use the pump to
extend the cylinder.
4. Place bottom of cylinder in line with lower pocket.
5. Raise and unblock lifting frame of unit.
6. Install truck cover(s) [see
7. Connect the battery connector to the truck.
Master Service Manual
Refer to the Parts Book for the correct tool
part number based on seal size.
page 84.]
2006-12-12