prime mover smx45 Master Service Manual page 81

Item
Description
No.
1 Wheel fork assembly
2 Load wheel
3 Fork, wheel
4 Bushing
5 Screw, set
6 Pin
7 Fitting, grease (optional)
8 Frame, lift
9 Lift cylinder
10 Screw
11 Nut
12 Screw
© BT Prime-Mover, Inc.
Return
Item
Description
No.
13 Bracket, lift limit
14 Frame, carrier
15 Screw
16 Link assembly, upper
17 Bushing
18 Nut
19 Pin
20 Screw
21 Screw
22 Link
23 Bushing
24 Pin
Removal
NOTE! To replace pull rods and/or bushings it is
easiest to work with the truck on its side.
Remove battery before turning truck over
on its side.
To eliminate hydraulic leaks, remove the breather (0.6875
inch [17.46 mm] and install a plug. The bushings on the upper
links of the carrier frame can be replaced by removing the
links and lift cylinder.
1. Park truck on a level surface and make sure
parking brake is applied and load wheels are
blocked to prevent accidental movement.
2. Release pressure in hydraulic system by pressing
the lowering button on steering control handle.
3. Lower the forks completely. Remove any load.
4. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
5. Disconnect the battery connector from the truck. If
applicable, remove bolts securing the battery to the
truck. Remove battery from the truck.
Master Service Manual 2006-08-03
F-code Section
PT S0.1
Version no T-code
001 SMX
Item
Description
No.
25 Pin
26 Screw
27 Pull rod assembly
28 Bushing
29 Screw
30 Screw
31 Pin
32 Pin
33 Spring, retainer
34 Nut
35 Washer
C-code
0300
Frame
79