Operating Parameter Programming; Display Part Numbers (Pn) - prime mover smx45 Master Service Manual

© BT Prime-Mover, Inc.
Return
Parameter 39
Determines whether the truck has a key switch or keypad and
what access level service personnel will have to the driver
parameters. This parameter is adjustable as follows:
• 1 = Key switch connected, driver parameters open
• 2 = Key switch connected, driver parameters must be
opened with service key
• 3 = Keypad connected, driver parameters open
• 4 = Keypad connected, driver parameters must be
opened with a service key.

3.5.2. Operating Parameter Programming

The following operating parameters may be programmed by
the operator:
• Parameter 1 - Slow speed range 10 - 40
• Parameter 2 - Fast speed range 70 - 98
• Parameter 3 - Acceleration range 30 - 90
• Parameter 4 - Deceleration range 40 - 90
• Parameter 5 - Automatic time off interval (with keypad
only) - from 0 minute to 20 minutes (a setting of "0"
disables automatic time off.)
Additional truck parameters may be viewed but cannot be
changed by the operator.

3.5.3. Display Part Numbers (Pn)

1. Enter special truck mode (see
2. Press and hold horn button until "Pn" is displayed.
3. Use the thumb control to scroll and display the
following information:
• HPn - Hardware part number
• HSN - Hardware serial number
• SPn - Software part number
4. End displaying the part number by pressing the red
"OFF" "O" key on the keypad.
Master Service Manual
F-code Section
PT S5.0
Electrical Functions
Version no T-code
002 SMX
page
2006-12-12
C-code
5000
168.)
179