Drive Wheel; Theory Of Operation; Maintenance; Drive Wheel Nut Inspection - prime mover smx45 Master Service Manual

© BT Prime-Mover, Inc.
Return

Drive Wheel

1. Theory of Operation

The drive wheel is mounted on the transmission drive axle.
The drive wheel is part of the drive unit assembly.
Drive Wheel Specifications
10 inch X 5 inch (255 X 125 mm)

2. Maintenance

See "Planned Maintenance Schedule" on page 61.

2.1. Drive Wheel Nut Inspection

1. Park truck on a level surface and make sure
parking brake is applied and load wheels are
blocked to prevent accidental movement.
2. Press red OFF button "O" on the keypad or turn
key switch OFF. Depress main ON/Off switch to
the OFF position.
3. Disconnect the battery connector from the truck.
4. Remove truck covers and bumper.
5. Hoist truck and securely block truck with drive tire
approximately 1 inch (25 mm) off the floor.
6. Visually inspect lug nuts for signs of being loose.
Inspect studs to see if one or more studs protrude
through the lug nut farther than the others. If either
condition exists, proceed as follows.
7. Loosen lug nuts to finger tight. If one or more studs
turn while loosening the lug nuts, proceed as
follows.
8. If any of the studs appear damaged, replace studs.
Service Manual 2006-08-04
F-code Section
PT S3.1
Drive Wheel
Version no T-code
001 SMX
C-code
3530
115