Changing Driver Accessible Parameters (P) - prime mover smx45 Master Service Manual

F-code Section
PT S5.0
Electrical Functions
Version no T-code
002 SMX
172
Return
C-code
5000
3.4. Changing Driver Accessible
Parameters (P)
WARNING
1. Enter special truck mode until "P" is displayed. The
parameter control indicator is illuminated (see
page
2. Use the thumb control to scroll to the driver
parameters to locate the one to change or view the
following truck parameter table. Scrolling in tractor-
first position will show parameters 1-40. scrolling in
the tractor-first direction will show parameters 40-1.
Press and hold horn button (S18-1 or S18-2) until
"P" is displayed.
3. Press horn button once to access the parameter
shown on the display. The parameter symbol (D)
on the display starts flashing.
4. Change parameter value by pressing the thumb
control up or down.
NOTE!
5. Press the horn button again to confirm the change.
The parameter symbol "O" on the display stops
flashing and remains illuminated (see
6. End programming by pressing the red OFF "O" key
on the keypad.
NOTE!
Master Service Manual
Modify specific truck parameters will
change the driving characteristics of the
truck.
168.)
Parameters 1-7 can only be modified, see
page 173. Parameters 10-40 can only be
viewed.
Moving the thumb control 1/4 - 3/8 inch
(6.35 - 9.25 mm) will show the parameter
display in digit "I" Releasing the thumb
control to neutral position will then display
the parameter value in digit III and IV,
depending on if it is a single or double digit
number.
page 168.)
2006-12-12