prime mover smx45 Master Service Manual page 82

F-code Section
PT S0.1
Frame
Version no T-code
001 SMX
80
Return
C-code
0300
6. Remove truck cover(s) [see
WARNING
7. Before disassembly, thoroughly clean exterior to
remove all contamination.
NOTE!
8. Turn truck on its side.
9. Remove set screw (29) and pin (32) connecting
wheel fork assembly (1) to lift frame (8). This
allows the wheel fork and pull rod (27) to drop.
10. Remove set screws (30) and pin (31) connecting
the pull rod (27) to wheel fork assembly (1).
11. Remove screw (20) from pin (19). Remove pin
(19).
12. Separate link (22) by removing setscrew (26) and
pin (25).
13. Remove bushings (28) and (23) and discard.
Master Service Manual
When using compressed air, wear effective
chip-guarding and
equipment Compressed
cleaning MUST be reduced to less than 30
psi (207 kPa).
Turn truck on its side where the pull rod is
to be repaired.
Wheel Fork
Set Screw
(Top View)
page 84.]
personal protective
air used for
2006-08-03