Main Components - prime mover smx45 Master Service Manual

© BT Prime-Mover, Inc.
Return

2. Main Components

1. Steering Control Handle:
The truck is to be controlled by the operator with 180 degree
steering angle. The truck has the ability to right-angle stack.
The brake is applied in the upper and lower position of the
steering control head.
2. Hydraulic unit:
Pump motor, pump, electric valve and oil tank integrated in a
compact unit.
3. Hydraulic lowering valve:
For controlling lifting and lowering functions with hydraulic
lowering valve.
4. Battery:
24 volt with different capacities and weights.
5. Drive unit with brake:
Drive unit with a electromagnetic brake assembly, drive motor,
drive wheel, and transmission assembly. The steering bearing
is located at the top of the drive unit.
6. Steering pivot point.
7. Data plate:
See data plate on
8. Operator Display:
Display includes hourmeter, error codes, parameters, hardware
and software part numbers.
9. Electrical panel:
24 volt electrical system. Truck speed is regulated by means of
a transistor controller.
10. Fuse/Circuit breaker:
10A, Fuse Keypad and ETAC (supplied with main harness)
10A, Fuse Main ON/OFF (supplied with main harness)
110A, Power Circuit Breaker
11. Load wheel:
Lubricate load wheels to prevent wheels from locking up. Load
wheels with sealed bearings.
12. Keypad:
Enter PIN-key code in the keypad and
the keypad starts truck. Press red OFF (O) on the keypad to
shut off electrical power to the control system. Up to 10
operators can be assigned their own individual PIN-key code
for access to the truck.
Master Service Manual 2006-12-12
F-code
PT
General Product Information
Version no T-code
001 SMX
page 36.
press green
Section C-code
M1.0
key (I) on
37