prime mover smx45 Master Service Manual page 116

F-code Section
PT S3.0
Parking Brake System
Version no T-code
001 SMX
114
Return
C-code
3300
4. Remove truck cover(s) [see
5. Loosen and remove mounting bolts (7). Remove
brake coil (6) assembly.
6. Remove friction disk (5) from hub (4).
7. Remove retaining ring (8) from hub (4).
8. Remove friction flange (3).
Installation
1. Inspect friction flange (3) for wear, replace if the
surface is worn unevenly. Install friction disk (5) on
hub (4). Place friction flange (3) on motor.
2. Install brake coil assembly on the motor end.
Adjust gap (see
to 50 in-lbs (5.6 N•m).
3. Connect the battery connector to the truck.
4. Remove blocks. Turn main ON/OFF switch to the
"On" position and turn key switch ON.
5. Test truck for proper operation before returning to
service.
6. Install truck cover(s).
Master Service Manual
page
Adjusting Screw
5
Figure 3-3: Brake Coil Assembly
page 111.) Torque mounting bolts
84.]
7
6
2006-08-04