Fork Section; Tractor Section; Lubricants; Standard - prime mover smx45 Master Service Manual

© BT Prime-Mover, Inc.
Return

1.1. Fork Section

1. Using the lift button, raise the forks to maximum
height.
2. Block the fork section. The tractor section will
remain on the floor.
3. Lower the forks on the blocks.
4. Press the red OFF (O) key on the keypad.
Disconnect the battery connector from the truck.

1.2. Tractor Section

1. Place jack in the designated jacking position.
2. Jack one side of the truck so that the drive tire is off
the floor no more than 1.0 inch (25.4 mm).
3. Block that side of the truck in place.
4. Jack the other side of the truck level with the first
side.
5. Block that side of the truck in place.

2. Lubricants

2.1. Standard

The standard conditioning truck is designed for operation in
temperatures down to 32 degrees F (0 degrees C).

2.2. Cold Storage

Trucks supplied with a cold storage conditioning package are
designed to operate in temperatures down to 5 degrees F (-
15 degrees C) in a continuous duty cycle or down to -13
degrees F (-25 degrees C) for intermittent operation. When a
truck is installed in a cold storage environment, change the
fluid in the hydraulic reservoir.
page 72.)
Master Service Manual 2006-08-03
F-code Section
PT P1.0
Introduction, Maintenance
Version no T-code
000 SMX
(See "Lubricants" on
C-code
59