prime mover smx45 Master Service Manual page 125

Electric walkie low-lift pallet truck
Hide thumbs Also See for smx45:
Table of Contents

Advertisement

© BT Prime-Mover, Inc.
Return
6. Drive the axle out of the load arm casing with a
hammer and brass drift pin.
7. Push the wheel out.
8. If bearings are to be reused, insert a brass drift pin
into each of the load wheel and knock bearings
out.
Installation
1. Install bearings in the new load wheel with seal
side out.
2. Place the new load wheel upright on a level
surface. Position the bearing over the load wheel.
Put a flat metal plate over the bearing and tap the
bearing in place with a plastic mallet. Make sure
the bearing is fully seated in the load wheel.
3. Align the wheel with the holes in the load arm
casting.
4. Install the axle through the load arm hole and
wheel. Align the "dimple" in the axle with the set
screw hole.
5. Install and tighten the set screw.
6. Lower truck and remove blocks.
7. Connect the battery connector to the truck.
8. Turn main ON/OFF switch to the ON position.
Enter key code and press the green ON button "I"
on the keypad.
9. Test truck for proper operation before returning to
service.
Master Service Manual
2006-08-04
F-code
Section
PT
S3.2
Load Wheels
Version no
T-code
001
SMX
C-code
3550
123

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents