Changing Service Parameters - prime mover smx45 Master Service Manual

F-code Section
PT S5.0
Electrical Functions
Version no T-code
002 SMX
Service Key
174
Return
C-code
5000

3.5. Changing Service Parameters

NOTE!
NOTE!
View Parameters with Service Key
When parameters 1-7 and 10 are viewed with the service
key, both the parameter (on the left side of the display, as
normal) and the driver number (on the right) are shown.
When the thumb control is rotated toward the forks, the
parameter
parameters 1 - 10, and then rolls over to the next driver (the
driver number increases.) There are ten drivers 1-9, (0 = 10th
driver.) If a parameter is changed, it is valid only for the driver
shown. Parameter 1 for the sixth driver is shown as an
example below:
Service Key
After scrolling through all drivers and driver parameters,
service parameters 11-40 will be displayed. Since these
parameters are valid for all drivers, no driver is shown.
Parameter 39 is shown as an example below:
Master Service Manual
A service key is required to change service
parameters.
1. Connect the service key at J41.
With service key connected, the truck does
not power ON using the keypad or key
switch.
2. Enter special truck mode (see
3. Press and hold horn button until "P" is displayed.
The parameter control indicator is illuminated (see
page 169.)
number increases,
0 1
3 9
page 168.)
progresses through
6
2006-12-12