prime mover smx45 Master Service Manual page 129

Item
No.
1 Caster Assembly
2 Fitting, grease
3 Pin
4 Cap
5 Bearing cup
6 Plate
7 Washer, thrust
© BT Prime-Mover, Inc.
Return
Item
Description
No.
8
9
10
11
12
13
14
Removal
Master Service Manual
Version no
Description
Bearing, thrust
Arm
Washer assembly
Nut
Nut
Washer, flat
Bearing
1. Park truck on a level surface and make sure
parking brake is applied and load wheels are
blocked to prevent accidental movement.
2. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
3. Disconnect the battery connector from the truck.
4. Hoist truck so caster wheel is approximately 2
inches (50 mm) off the floor and securely block.
5. Before disassembly thoroughly clean exterior of
the caster assembly in a cleaning solution to
remove all contamination.
6. Remove caster assembly screws from bumper.
Remove caster assembly and take to a suitable
work area.
7. Remove nuts (11) and (12) and washers (10) from
screws (16) and (17). Remove screws (16) and
(17) from assembly. Remove arms (9).
8. Remove flat washers (13) and bearings (14) from
wheel (15). Inspect bearings (14).
9. Disassemble housing (19) by removing pin (3), cap
(4), and plate (6). Remove bearing (5) from plate
(6). Remove O ring (20), thrust washers (7), and
thrust bearing (8) from housing (19). Inspect
bearings (5) and (8).
2005-07-11
F-code Section
PT S3.3
Caster Wheel (Optional)
T-code
001 SMX
Item
Description
No.
15 Wheel
16 Screw
17 Screw
18 Block, torsion
19 Housing
20 O Ring
C-code
3560
127