prime mover smx45 Master Service Manual page 108

F-code Section
PT S2.0
Transmission
Version no T-code
001 SMX
106
Return
C-code
2550
5. Install second stage gear set (10) and (17).
NOTE!
6. Install pinion gear (20), woodruff key (21), and
retaining ring (19) on the armature shaft.
7. Apply sealant
surface and install gear case cover (11). Install
lockwashers (15) and screws (14). Torque cover
screws (14) to 30 ft-lbs (42 N•m).
Installation
CAUTION
NOTE!
1. If
assembly (22).
2. Reinstall drive unit assembly through the pivot
frame while feeding the harness and cables
through the pivot frame mount.
3. Secure
lockwashers (16).
4. Connect cables/wire to terminal block on the
transmission.
5. Connect arm angle switches.
6. Connect stem harness to main harness and slide
the connector back onto the metal support tab.
NOTE!
7. Install stem mount.
Master Service Manual
The seal must be installed correctly with its
open side and seal ring positioned towards
the bearing.
Ensure the motor end cap is installed
before proceeding to the next step.
(GE Weicon
Make sure the main ON/OFF switch is OFF
and the battery connector is removed from
truck before proceeding.
Call-outs in the following procedure refer to
illustration on page
removed earlier, install
assembly with
Replace any wire ties that were removed
during reassembly.
Silmate) on the mating
101.
steering bearing
screws (15) and
2006-08-04