prime mover smx45 Master Service Manual page 106

F-code Section
PT S2.0
Transmission
Version no T-code
001 SMX
104
Return
C-code
2550
8. Disconnect arm angle switches.
9. Remove screws from stem mount securing
steering control handle assembly to the drive unit
assembly.
10. Disconnect cable/wires from the terminal block on
the transmission.
11. Remove bolts (15) and lockwashers (16) securing
transmission assembly and bearing assembly to
frame.
WARNING
12. Remove
assembly by lowering it through the pivot-frame
mounting.
13. Feed the control wiring harness and power cables
through the transmission pivot mount.
14. Drain gear case lubricant.
15. Remove drive wheel (see
Master Service Manual
Wiring Harness
Connector
Arm Angle Switches
Figure 2-3: Handle Harness
Transmission assembly may fall free from
mounting after bolts are removed causing
damage to assembly or injury to personnel.
transmission and
page
steering bearing
117.)
2006-08-04