prime mover smx45 Master Service Manual page 141

© BT Prime-Mover, Inc.
Return
Installation
NOTE! Place finger between housing (21) and
reverser button (14) to hold right rocker (33)
in place while installing housing (21).
1. Install thumb wheel assembly (30).
2. Install lift/lower button (44).
3. Install horn button (15) and (41).
NOTE! Do not force housing (21). Install carefully.
4. Install housing (21) and secure with screws (22).
5. Connect the stem harness to ETAC (19).
NOTE! Make sure stem harness is properly routed
before installing top cover.
6. Install top cover (16) and hold firmly in place while
securing with screws (4) and (8).
7. Plug in key pad (6) in handle (3). Secure with
screws (7).
8. Remove blocks.
9. Connect the battery connector to the truck.
10. Turn main ON/OFF switch to the ON position.
Enter key code and press the green ON button "I"
on the keypad.
11. Test truck for proper operation before returning to
service.
Master Service Manual 2006-08-07
F-code Section
PT S4.1
Steering Control Head
Version no T-code
001 SMX
C-code
4100
139