prime mover smx45 Master Service Manual page 130

F-code Section
PT S3.3
Caster Wheel (Optional)
Version no T-code
001 SMX
128
Return
C-code
3560
Installation
WARNING
1. All parts should be cleaned and dried thoroughly.
Metal parts should be lightly oiled prior to
reassembly.
2. Pack all bearings with grease (see
3. Install O ring (20), thrust bearing (8), and thrust
washers (7) in housing (19).
4. Install bearing (5) and cap (4) in plate (6). Install
plate (6) on housing (19) and secure with pin (3).
5. Install bearings (14) and flat washers (13) in new
wheel (15).
6. Install arms (9) on housing (19) and secure with
screws (16) and (17), washer (10), and nuts (11)
and (12).
7. Install caster assembly to bumper and secure with
screws.
8. Connect the battery connector to the truck.
9. Remove blocks. Turn main ON/OFF switch to the
ON position. Enter key code and press the green
ON button "I" on the keypad.
10. Test truck for proper operation before returning to
service.
Master Service Manual
When using compressed air, wear effective
chip-guarding and
equipment. Compressed
cleaning MUST be reduced to less than 30
psi (207 kPa).
personal protective
air used for
page 72.)
2005-07-11