Services Performed Every Two Months Or Every 250 Operating Hours; Frame; Motors; Drive Unit - prime mover smx45 Master Service Manual

© BT Prime-Mover, Inc.
Return
2.3. Services Performed Every Two Months
or Every 250 Operating Hours
The following inspections are to be made by the operator
prior to each operating shift. It is the operator's responsibility
to report any problems with the truck to the appropriate
personnel. The truck should not be operated until it has been
inspected and repaired by a trained, qualified, and authorized
technician. The operator is ultimately responsible for the safe
operation of the truck.

2.3.1. Frame

Check frame for crack formation and damage. Check cover
screws and secure as necessary.

2.3.2. Motors

When using compressed air, wear effective
WARNING
chip-guarding
equipment.
cleaning MUST be reduced to less than 30
psi (207 kPa).
Check motors for improper connections due to poor
connections. Check tightness on all connections. Blow
carbon, copper, and plastic particle accumulations out from
the motor using compressed air. Check for signs of oil on the
motor air vents. Check for any damage to the air vents. For
minimum brush lengths see

2.3.3. Drive Unit

Check oil in the drive housing. Check for contamination in the
oil (see page 100.)

2.3.4. Brake

Check brake of dust and debris. Check brake disk for wear.
1. Remove brake coil, and inspect brake disk for
wear. If the brake disk is damaged or worn, replace
with a new disk.
2. Before replacing the brake disk see

2.3.5. Electrical Control System

Check control handle arm angle switches for adjustment (see
page 220.)
Master Service Manual 2006-08-03
F-code Section
PT P2.0
Service Schedule
Version no T-code
001 SMX
and personal
Compressed air used for
page 51 or page 52.
page
C-code
protective
112.
67