Converting Keypad To Key Switch - prime mover smx45 Master Service Manual

Main ON/OFF Switch
© BT Prime-Mover, Inc.
Return
4. Turn main ON/OFF switch to the ON position.
5. Test truck for proper operation before returning to
6. Install truck cover(s).

4.6. Converting Keypad to Key Switch

Removal
1. Lift forks to maximum height.
2. Remove truck cover(s) [see
3. Using the service key (see
4. Press red OFF button "O" on the keypad. Depress
5. Disconnect the battery connector from the truck.
6. Disconnect the wires from the main ON/OFF
7. Remove main ON/OFF switch mounting bracket
Installation
1. Install new main ON/OFF switch and key switch
2. Install original main ON/OFF switch into new
Keypad
Cover
3. Install key switch in mounting bracket.
4. Remove jumper wire between wire 20 and 22 (see
Keypad
5. Remove screw from keypad. Remove keypad.
6. Install new keypad cover.
7. Remove service key.
8. Connect the battery connector to the truck.
Master Service Manual
F-code
PT
Version no
001
Enter key code and press the green ON button "I"
on the keypad.
service.
parameter 39 to 1 or 2 (see
main ON/OFF switch to the OFF position.
switch. Remove main ON/OFF switch.
(see page 223.)
mounting bracket.
mounting bracket. Connect the wires that were
removed earlier to the main ON/OFF switch.
page 194.) Connect the wires 20 and 22 to new
key switch.
2006-08-08
Section C-code
S5.4 5310
Switches
T-code
SMX
page 84.]
page 174), change
page 174.)
227