prime mover smx45 Master Service Manual page 211

© BT Prime-Mover, Inc.
Return
(4) Connect the capacitor leads in the charger.
(5) Set AC voltmeter on a scale to read at least
(6) Turn on charger power.
Before checking components, disconnect
WARNING
AC power supply, unplug batteries and
discharge
screwdriver. All tests should be made with
the charger disconnected unless otherwise
stated. Use extreme caution when a test
calls for the power to be "on" at the charger.
5. Overcharging problems
Most complaints about charging problems can be
remedied by following the previous procedures.
Overcharging problems may not be the fault of the
charger. Often, overcharging is caused by bad
batteries or poor connections. The following items
should be checked to resolve problems of
overcharging or failure of charging amps to taper
down.
a. Charger and battery not properly matched.
Check specifications on both batteries and
charger.
designed for a specific size and type of battery.
If another battery has been installed, be certain
Master Service Manual 2006-08-08
F-code
PT
Swing Out Battery Pack
Version no
002
On a good capacitor, the needle will deflect
to the right (low resistance) and then deflect
back to the left (high resistance) each time
the meter leads are reversed. On a shorted
capacitor, the needle will deflect to the right
(low resistance) and remain there. On an
open capacitor, the needle will not deflect
(stationary display.)
500 volts AC. Connect the meter leads to
the capacitor terminals.
A shorted capacitor will indicate 0 volts AC.
An open capacitor will indicate about 300
volts +/-20 volts AC. This is the same as the
capacitor transformer
without a capacitor connected in circuit.
capacitor
Battery pack
Section C-code
S5.2 5110
T-code
SMX
winding voltage
with insulated
(GNB) has been
209