prime mover smx45 Master Service Manual page 260

F-code Section
PT S6.0
Hydraulic System
Version no T-code
001 SMX
Lift Cylinder Hose
258
Return
C-code
6000
1. Lower forks.
2. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
3. Disconnect the battery connector from the truck.
4. Remove truck cover(s) [see
5. Disconnect lift cylinder hose at the hydraulic
cylinder.
NOTE!
6. Insert hose in a waste fluid container.
7. Connect the battery connector to the truck.
8. Turn the main ON/OFF switch to the ON position.
Enter key code and press the green ON button "I"
on the keypad.
9. Run hydraulic pump by pressing the lift button until
all hydraulic fluid is pumped from the system.
10. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
11. Disconnect the battery connector from the truck.
12. Connect the lift cylinder hose.
13. Remove vent plug and fill reservoir to within 1
inch (25.4 mm) below the filler port elbow with
recommended fluid (see
reservoir capacity is 0.8 quart (0.75 liter). Replace
vent plug.
14. Install truck cover(s).
15. Connect the battery connector to the truck.
16. Turn the main ON/OFF switch to the ON position.
Enter key code and press the green ON button "I"
on the keypad.
17. Raise and lower forks several times to purge air
from the system.
18. Properly dispose of waste fluid.
Master Service Manual
Wear protection eye and face gear when
draining oil.
page
page 84.]
72.) The usable
2006-08-08