Main On/Off Switch; Arm Angle Switches - prime mover smx45 Master Service Manual

F-code Section
PT S5.4
Switches
Version no T-code
001 SMX
224
Return
C-code
5310
The switches can not be repaired or rebuilt. Replace a bad
switch with new as necessary.

4.1. Main ON/OFF Switch

Removal
1. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
2. Disconnect the battery connector from the truck.
3. Remove truck cover(s) [see
4. Disconnect the wires from the switch.
5. Remove main ON/OFF switch.
Installation
1. Install new main ON/OFF switch and connect the
wires to the switch terminal.
2. Connect the battery connector to the truck.
3. Turn the main ON/OFF switch to the ON position.
Enter key code and press the green ON button "I"
on the keypad.
4. Test truck for proper operation before returning to
service.
5. Install truck cover(s).

4.2. Arm Angle Switches

Removal
1. Lower the forks completely.
2. Press red OFF button "O" on the keypad. Depress
main ON/OFF switch to the OFF position.
3. Disconnect the battery connector from the truck.
4. Remove truck cover(s) [see
5. Disconnect the wires on the switch.
6. Remove the screws holding the switch on the
mounting bracket. Remove switch.
Master Service Manual
page 84.]
page 84.]
2006-08-08