prime mover smx45 Master Service Manual page 83

© BT Prime-Mover, Inc.
Return
Installation
When using compressed air, wear effective
WARNING
chip-guarding
equipment
cleaning MUST be reduced to less than 30
psi (207 kPa).
1. All parts should be cleaned and dried thoroughly.
Metal parts should be lightly oiled prior to
reassembly.
2. Press new bushing (23) into link (22). Push new
bushing (28) in pull rod (27).
3. Assemble pull rods (27) on links (22) to fit in frame
channel.
4. Install pins (19) and screws (20) in link (22).
5. Install pin (31) connecting pull rod (27) to wheel
fork assembly (1). Secure with set screws (30).
6. Install pins (32) in wheel fork assembly (1) and lift
frame (8). Secure with set screws (29).
7. If applicable, lubricate grease fitting (see
before turning truck back upright.
8. Return truck to the upright position.
9. Install battery on truck. If applicable, secure battery
bolts to the truck. Install truck cover(s) [see
page 84.]
10. Connect the battery connector to the truck.
DO NOT use your hands to check for
WARNING
hydraulic
cardboard or paper to search for leaks.
Escaping
penetrate the skin causing injury. Relieve
pressure before disconnecting hydraulic or
other lines. Tighten all connections before
applying pressure. Keep hands and body
away from pinholes and nozzles which
eject fluids under high pressure.
Master Service Manual 2006-08-03
F-code Section
PT S0.1
Version no T-code
001 SMX
and personal
Compressed air
leakage. Use a
fluid under pressure
C-code
0300
Frame
protective
used for
page 72)
piece of
can
81