© BT Prime-Mover, Inc.
Return
2.1.4. Cables and Connections
Tighten connections. Check all cable insulation for damage.
Check that all electrical connections are clean and tight. Plug-
in connectors should be unplugged and plugged back in to
clean terminals.
2.1.5. Grease Location Points
For location of the grease points see
2.2. Services Performed Daily or Every 8
Operating Hours
Daily inspection is to be made by the operator prior to each
operating shift. It is the operator's responsibility to report any
problems with the truck to the appropriate personnel. The
truck should not be operated until it has been inspected and
repaired by a trained, qualified, and authorized technician.
The operator is ultimately responsible for the safe operation
of the truck.
2.2.1. Frame
Check truck data plate and decals to see that data is legible.
2.2.2. Brakes
Check operation of brakes.
2.2.3. Wheels/Tires
Inspect wheels and tires for wear and damage. Remove any
steel chips and foreign material to prevent damage to the
wheels. Check for gouging and chunking of the surface.
Trash that is wrapped around wheels and axles will cause
premature tire wear and bearing damage. The floors should
be kept clear of trash to prevent damage to the wheels and
tires.
2.2.4. Steering Control Handle
Check return of control handle to upper rest position.
Master Service Manual
2006-08-03
F-code
Section
PT
P2.0
Service Schedule
Version no
T-code
001
SMX
page
72.
C-code
65