prime mover smx45 Master Service Manual page 177

Parameters 1-7 (driver number) and Driver Parameters, 10-40 are Service Parameters
Parameter Name
10 Pin code
(keypad only)
14 Creep speed
20 Hourmeter
selection
21 Battery size
(The lower the
number, the
deeper the
discharge to
the battery.)
25 Service
interval
39 Access code
© BT Prime-Mover, Inc.
Return
If display/access for a service parameter is required, it is
faster to initially rotate the thumb control away from the forks
(go backwards through parameters/drivers.) The parameter
number displays briefly, then if the thumb control is not
rotated further the parameter value is displayed.
Service Parameters
Unit Range Step Default
0 to 9999 1
-10 to 10 1
1 to 5 1
1 to 20 1
hours 0 to 2000 50
1 to 4 1
Master Service Manual
F-code
PT
Electrical Functions
Version no T-code
002 SMX
Description
1 Can set up to 10 PIN codes (need Service Key to
access this.)
Note: 0 disables a driver (the 2nd through 10th
driver's default PIN is 0), if all drivers are disabled
the truck cannot be driven without the service key,
and if two drivers have the same PIN, the higher
number driver's parameters will be used.
-5 Defines speed at low throttle positions; a negative
number enhances low speed maneuverability, a
positive number makes the truck more responsive
2 1 (A.) = key time
2 (b.) = activity time (drive, lift or lower)
3 (c.) = drive
4 (d.) = lift
5 (s.) = time to service
(if parameter 25 = 0, the power-on 5 second hour
meter display is skipped and 5(s) is not shown
during Hourmeters special truck mode.) Time to
service counts backward from value of parameter
25 to zero and decrements the same as 2(b.)
increments.
8 Defines battery capacity;
represents larger capacity battery (the truck will
allow the battery to become more discharged given
the same displayed battery state-of-charge.) In
other words, if the battery state-of-charge reaches
0% too soon (the battery still contains adequate
charge to continue operation), this parameter
should be increased. The battery state-of-charge is
reset when the battery voltage is above 25.2V.
0 Sets service timer. C29 will display when time is
up. To reset service timer, access this parameter
without changing the value. To disable the service
timer, set this parameter to 0. See parameter 20 on
page 178.
3 Defines whether truck has key switch or keypad
and what access level personnel will have to
parameters
1=key switch/driver parameters open
2=key switch and closed
3=keypad and open
4=keypad and closed (when closed, service key is
required to access driver parameters)
2006-12-12
Section C-code
S5.0 5000
higher number
175