wsm L503 Workshop Manual page 48

L3130 · L3430 · L3830 · L4630 · L5030, WSM
Adjusting Toe-in
1. Park the tractor on the flat place.
2. Inflate the tires to the specified pressure.
3. Turn steering wheel so front wheels are in the straight ahead
position.
4. Lower the implement, lock the parking brake and stop the engine.
5. Measure distance between tire beads at front of tire, hub height.
6. Measure distance between tire beads at rear of tire, hub height.
7. Front distance should be 2 to 8 mm (0.079 to 0.315 in.) less than
rear distance.
8. If the measurement is not within the factory specifications, adjust
by changing the tie-rod length.
Toe-in (B - A) Factory spec.
Adjusting
1. Detach the snap ring (1).
2. Loosen the tie-rod nut (2) and turn the tie-rod joint (3) to adjust
the tie-rod length until the proper toe-in measurement is
obtained.
3. Retighten the tie-rod nut (2).
4. Attach the snap ring (1) of the tie-rod joint.
Tightening torque Tie-rod lock nut
IMPORTANT
• A right and left tie-rod joint is adjusted to the same length.
(1) Snap Ring
(2) Tie-rod Nut
(3) Tie-rod Joint
G-28
G GENERAL
2 to 8 mm
0.079 to 0.315 in.
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123 to 145 ft-lbs
(A) Wheel to Wheel Distance at front
(B) Wheel to Wheel Distance at rear
(C) Front
W1082751
KiSC issued 02, 2007 A