Disconnect Terminal From Connector - Toyota Automobile Electrical Repair And Modification

TERMINAL AND CONNECTOR REPAIR–TERMINAL REPLACEMENT
Locking Clip
Connector
"Waterproof Type"
Terminal
Retainer
Special
Tool
4.

Disconnect Terminal from Connector

(a)
Pull Out
(b)
Wire Harness
(c)
(d)
(e)
Locking
Clip
Wire Harness Repair Manual (RM1022E)
Determine the primary locking system from the
charts.
1. Lock Located on terminal
2. Lock Located on connector
3. Method of entry and operation
Push the terminal gently into the connector and hold
it in this position.
Insert the special tool into the connector in the
direction shown in the chart.
Move the locking clip to the unlock position and hold
it there.
NOTE: Do not apply excessive force to the terminal.
Do not pry on the terminal with the special tool.
Carefully withdraw the terminal from the connector by
pulling the lead toward the rear of the connector.
NOTE: Do not use too much force. If the terminal
does not come out easily, repeat steps (a) through
(e).
B–25
41