Skip Setting For The Dr Mode Scan; D Individual Skip Setting; D Group Skip Setting - Icom ID-31A Advanced Instructions

Previous view
4
DR MODE <ADVANCED>

■ Skip setting for the DR mode scan

You can set the unnecessary repeaters to scan skip
targets. The selected repeaters are skipped during
scanning for faster selection and scanning.
You can set the skip setting to all repeaters in the se-
lected repeater group, or the individual repeater.
When a repeater is specified as a skip target, its
"USE (FROM)" setting is automatically set to "NO."
In this case, the repeater cannot be selected to
"FROM" (Access repeater).

D Individual skip setting

Push [MENU]
q
Push D-pad( ) to select the root item ("DV Memo-
w

ry"), and then push D-pad(Ent).
D-pad
(Ent)
(�)
Push D-pad( ) to select "Repeater List," and then
e 
push D-pad(Ent).
Push D-pad( ) to select the repeater group that in-
r 
cludes the repeater you want to set the skip setting
on, and then push D-pad(Ent).
Push D-pad( ) to select the repeater to be skipped
t

during the DR mode scan.
Push .
y
Push D-pad( ) to select "SKIP," and then push D-
u 
pad(Ent).
• "SKIP" appears on the selected repeater.
• Push and select "SKIP" again, then push D-pad(Ent)
to cancel the skip setting.
• When "SKIP All ON" is selected, push D-pad(Ent) to set
all repeaters in the group as skip targets.

D Group skip setting

Push [MENU]
q
Push D-pad( ) to select the root item ("DV Memo-
w 
ry"), and then push D-pad(Ent).
Push D-pad( ) to select "Repeater List," and then
e 
push D-pad(Ent).
Push D-pad( ) to select the repeater group to be
r 
skipped during the DR mode scan.
Push .
t
Push D-pad( ) to select "SKIP All ON," and then
y 
push D-pad(Ent).
• "SKIP" appears on the selected repeater group.
• Push again and select "SKIP All OFF," then push
D-pad(Ent) to cancel the skip setting.
While in the DR mode, and
if you select "Repeater List"
on the FROM SELECT
screen, you can set the
skip settings in the same
way as described above.
.
.
4-32
Select the repeat-
er to set the skip
setting
Appears
Select the repeat-
er group to set the
skip setting
Appears